Description
Wall Mounted Oil Lamp, Clear – Frosted Shade
Vintage Bracket Lamp
Size
- Projection from wall: 13″
- Total height: 18″
- Type: Oil burning
- Takes a 7/8″ width wick, included
- Use with lamp oil, Not-Included
- Install oil lamp guide below
Wall Mounted Oil Lamp produces a lovely soft light. The ruffle topped frosted glass lamp shade has a lace pattern. When lit this delicate design is eye-catching.
Black lamp arm and support are made of sturdy cast iron. Arm can be readily shifted to best position. Lamp shade is frosted glass. Font is clear glass with embossed edge. Glass chimney is clear glass. Bracket oil lamp burns approximately 0.5 ounces of lamp-oil per hour.
Oil Lamp Guide
- Only use “lamp oil” as a fuel source. Other oil types can cause fires and/or damage oil burners.
- Leave at least a ½ inch of head-space when filling up your oil lamp.
- Keep lamp reservoir half full so that wick stays properly saturated
- Oil lamps burn approximately ½ ounce of lamp oil per hour.
- Trim off charred edge of wick after every couple uses. If charred residue is not kept trimmed, wick will likely smoke and provide dim light.
- Replace lamp chimney once lamp is lit to protect flame from drafts.
- Oil lamps are only for indoor use.
- Caution: A burning oil lamp should not be left unattended. Lamps should be placed out of the reach of children.
Install Bracket Oil Lamp
Determine placement of wall lamp
- Oil lamp should-not be positioned near any combustible source
- Heat must have space to escape lamp chimney
- Lamp hangs from matching support-bracket
- Support-bracket is attached by 2 screws
- When installing be sure to screw bracket to a wall-stud
- Once attached to wall, slide post on end of lamp-bracket into support-bracket.
- Pour lamp oil into font
- Screw oil-lamp-burner into glass lamp font.
- Place font in bowl-shaped area of lamp bracket
- Position chimney on burner so that tines hold chimney in place
